FlashWall Bracket Kit

Accurate bracket spacing is essential so the side closers connect and seal correctly. Follow the measurement and side-closer customization instructions for your model.

When bonding to glass, clean and dry the surface first and allow the adhesive to cure before applying load. The guide lists a utility knife, measuring tape and two-component acrylic glue for wall-bracket pre-installation; the fixing method depends on the substrate.

Follow the complete wall-bracket deployment instructions. Unfold and straighten the canvas and latex layer, compress the bottom gasket as instructed and tighten the side-closer wheels. Incorrect setup can increase seepage.

Use on flat, continuous, clean, non-permeable ground that allows full contact with the barrier. Sweep the deployment area first. Gravel, sand, grass and grates are unsuitable.

FlashWall inhibits water entering through building entry points. It does not protect against water permeating through the ground, walls or window and door frames. Correct installation, maintenance and storage are essential.

After use in floodwater, rinse with clean water and dry fully before storage. Do not use strong alkaline or acidic detergents, thinner or benzene. Store indoors, protected from damage, with no heavy weight on the system.

Repair visible damage before use. The 2024 guide specifies an operating temperature range of -5°C to 50°C and a reuse limit of 30, conditional on correct use, cleaning, maintenance and storage.